Powder Mixed Electrical Discharge Machining

Authors

  • Virat Vidhata Student, Department of Mechanical Engineering, J. S. S. Academy of Technical Education, Noida, India
  • Kumar Shubham Student, Department of Mechanical Engineering, J. S. S. Academy of Technical Education, Noida, India
  • Manish Lalchandani Student, Department of Mechanical Engineering, J. S. S. Academy of Technical Education, Noida, India
  • Kamlapati Sharma Student, Department of Mechanical Engineering, J. S. S. Academy of Technical Education, Noida, India
  • M. S. Chandrashekara Assitant Professor, Department of Mechanical Engineering, J. S. S. Academy of Technical Education, Noida, India

Keywords:

EDM, MRR, SR, TWR, PMEDM

Abstract

Electrical discharge machining in the recent years has emerged as a very advanced technique for machining electrically conductive materials that are very hard to machine. Edm was developed as a electro- chemical process to overcome challenges faced by conventional methods like shaping extremely hard, complex and intricate profiles, shapes and contours but still had its own set of limitations. With time advancements were made to improve this process by adding ceramic powder to dielectric fluid. This paper reviews powder mixed edm, the effect of powder and how the optimization of parameters leads to subsequent improvement in metal removal rate, surface finish and tool wear rate using inconel 718.

Downloads

Published

12-07-2021

How to Cite

[1]
V. Vidhata, K. Shubham, M. Lalchandani, K. Sharma, and M. S. Chandrashekara, “Powder Mixed Electrical Discharge Machining”, IJRAMT, vol. 2, no. 7, pp. 13–16, Jul. 2021.

Issue

Section

Articles