Modelling and Simulation of Perturb and Observe Algorithm on Solar PV Water Pumping System using Different Controllers in MATLAB/Simulink

Authors

  • Trinath Pennenti PG Student, Department of Electrical and Electronics Engineering, Helapuri Institute of Technology and Science, Eluru, India
  • Ch. Koteswara Rao Assistant Professor, Department of Electrical and Electronics Engineering, Helapuri Institute of Technology and Science, Eluru, India

Keywords:

Maximum Power Point Tracking (MPPT), Vector Oriented Control (VOC), Voltage Source Inverter (VSI), Photo Voltaic (PV) Array, DC to DC Boost Converter

Abstract

This paper deals with the Perturb and Observe algorithm on a Photovoltaic System using different Controllers in MATLAB/Simulink. The Photovoltaic System is depends on the mathematical equations. The P & O algorithm is the Maximum Point Tracking Technique (MPPT) to track the maximum power point. A high level boost converter is used between solar panel and the PWM inverter. The DC voltage is maintained constant by controlling the duty cycle of boost converter. Three phase Voltage Source Inverter (VSI) is maintain constant supply to PMSM under change in solar irradiation to regulate discharge of water. The performance of system employing PMSM drive with PI controller and fuzzy logic controller is analyzed. The current and voltage ripple harmonics will be reduced and THD (total harmonic distraction) also reduced. The Modelling and Simulation of Perturb and Observe Algorithm is done by using Different Controllers in MATLAB/Simulink.

Downloads

Download data is not yet available.

Downloads

Published

25-07-2020

How to Cite

[1]
T. . Pennenti and C. K. Rao, “Modelling and Simulation of Perturb and Observe Algorithm on Solar PV Water Pumping System using Different Controllers in MATLAB/Simulink”, IJRESM, vol. 3, no. 7, pp. 244–249, Jul. 2020.

Issue

Section

Articles